Finesse Block Filler SBL Acrylic
Product Code: 312-100
Product Description
A Styrene Acrylic Block Filler for interior and exterior surface. It is a heavy bodied, high solids, filling coat to provide a smooth profile over rough substrates.
Areas of Use
All types of brick and masonry surfaces. Not recommended for timber or large movement substrate.
Coverage
Approximately 8 square metres per litre per coat. Spreading rate varies depending on surface condition and application technique
Volume Solids: 42%
Method of Application
- Brush, roller or spray
- Satisfactory with most equipment
- Observe the State Spray Painting Regulations
- Stir well before use using a broad, flat paddle in a scooping motion
- Do not apply if temperature is below 10C or likely to fall below 10C during drying
- Do not apply if rain is expected or in excessively hot, dry conditions
Drying
Dries 20-30 minutes and may be recoated after 2 hours at 25C. In damp, cool or humid conditions, drying will be extended. Temperature must be above 10C during drying and application.
Clean Up
Clean all equipment with water.
Surface Preparation
Previously Painted Surface
Remove loose or flaking paint. Remove all traces of grease, dirt, oil or smoke stains using a suitable detergent. Wash with clean water and allow to dry. Repair any cracks or surface defects with a good quality filler. Sand surface until smooth and dust off with a cloth. Glossy surfaces should be sanded to remove gloss. Patchy surfaces require a coat of Australis PerfectPrep (undercoat).
Previously painted surfaces must be sound and have good adhesion. This can be checked by cutting an “X” in the surface with a sharp blade, press a piece of clear tape over the “X” as firmly as possible with the ball of the thumb then as quickly as possible, tear off the tape in one movement. If the previous paint comes off it must be removed before repainting.
Note: Mould, fungal infected surfaces and efflorescence must be treated to eliminate the possibility of recurrence.
Unpainted Paperfaced Wallboard, Fibro, Brick or Cement Surface
Dust down surfaces and apply one coat of Australis PerfectPrep.
Unpainted Fibrous Plaster
Dust down surface and apply one coat of Australis G.P. Oil Based Undercoat or Australis Binder Sealer.
Sizes
4 Ltrs, 20 Ltrs.
View the Material Safety Data Sheet (MSDS) for information regarding Health and Safety, First Aid, and Paint Disposal Procedures.